Step 7 vent the waste lines.
Running plumbing through floor instead of outside wall.
And pipes running straight through wood studs and joists are fine too just protect the pipe in areas where it bends as it passes through.
When running the pipes through the studs first be sure to drill the holes in the center so that when it s time to hang the wall board the screws or nails don t reach the pipes and damage the pipes.
Vent the waste and drain lines when you are installing the piping in a vertical direction.
Placing water pipes in outside walls greatly increases the risk of frozen and burst pipes in cold climates.
Running drainpipe through joists calls for meticulous work.
Inside pipes can be run vertically to accommodate new plumbing.
Similar to the chase is the soffit.
Drill holes cut pipes and connect them in a dry run using drain fittings.
This needs to extend through to the roof.
Often the most economical way to replace the original plumbing is running pvc cpvc or pex tubing through existing walls ceilings and crawl spaces.
If you are plumbing a vanity consider coming up through the floor rather than in the wall.
We re all taught not to run plumbing in exterior walls.
Sometimes the wall is insulated but not the rim joist between floors and you get freezing there.
Use a carpenter s level to mark the studs for drilling holes.
Pipes that are encased in concrete for in floor heating for example are ok because the concrete holds them in place.
While homeowners may fret over running plumbing lines through the ceiling it is a common practice used to minimize damage during the re plumb and to keep labor costs lower.
When running pipes from a slab to an attic use an inside wall.
Instead of running from floor to ceiling a soffit runs across the top of a wall.
The holes must follow a straight line across the floor and must ascend or descend so the pipe will be sloped 1 4 inch per foot.
When remodeling bathrooms we always plan to install all plumbing lines inside interior walls and avoid running plumbing in exterior walls due to the reality of the pipes freezing.
The chase is most commonly used for running new vent stacks.
If joists are 16 inches on center and pipes run across them at a right angle holes should differ in height by about 3 8 inch.
Run the horizontal vent lines sloped downward toward the fixtures at a rate of 1 8 to 1 4 inch per running foot.
If your pipes are going in a lateral direction make notches in the studs instead of drilling holes in them.
You need to make sure that you use black plastic that is 1 1 2 inch in size.
In most cases the lines will come through the floor.
Or just a little breeze of cold air such as a crack in a crawlspace or top of a basement wall is just enough to freeze a couple of inches of pipe.
When you need plumbing in exterior walls.
